Professional plumbing is often a very expensive service, and usually the work that is done is something that any homeowner could solve fairly easily with the proper knowledge and tools. If you’d like to start learning to solve your own plumbing problems, read on to see what you can do.
When concerned with plumbing, you need to know what can cause noisy pipes. This is important because it can mean the difference between an annoying noise and flooding in your house. Do your research to distinguish between the different noises and hire a professional if any serious risk is posed.
To avoid having your outdoor faucets freeze up in the winter, detach all hoses before the first freeze. Also, close the shutoff valve that leads to the outdoor faucets, then turn on the outdoor faucets to let any remaining water in the lines drain. Once temperatures warm up in the spring, you can reverse the process.
Use strainers in all drains to catch hair and other objects. This will prevent all the material from going down the drain and causing a clog, which can cause a bigger problem down the line. Clean out the strainers daily so that you don’t start getting backup of water in your sink or tub.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
One way to prevent pipes from freezing during the winter is to keep cabinet doors in your house that contain the pipes open. This can insure that they get adequate heat to keep warm. Make sure also, to unhook and kind of hose outside and run a little water to clear the pipes of any remaining water going outside.
If you have to replace any of your shower heads, make sure that the replacement is the best one you can afford. Choosing the cheapest shower head in the store can end up costing you more in the long run. Cheap shower heads are not well-made and are very likely to break. Buying a cheap shower head will end up costing you more money over the long-term.
If your plumbing is making strange noises you may have lost something called your “air cushion”. To turn this back on, you’re going to need to turn off your main water supply. Run all faucets in your house and then turn back on your main water supply. This should make everything sound better again.
Frozen pipes can cause a lot of damage and cost you money. However, this can typically be prevented. The first thing to do is make sure that all of the outside pipes are well insulated. When colder weather is approach, disconnect your garden hoses and make sure the outside water fixtures are turned off. This will keep you from paying too much to your plumber.
Do not ignore a slow flushing toilet. This is usually a sign that something is wrong. It can also cause backups and overflows. The most common causes of a slow flushing toilet are sediment build up, tank malfunctions, or partial clogs. You should periodically check for these problems.
Before embarking on a plumbing project, make sure that you’re aware of where the shutoff valve for water in your home is, as well as the valves for shutting off individual structures like sinks, toilets, etc. This way, if something goes wrong, you’ll be able to stop the water flow.
As you can see, plumbing isn’t as difficult as you may have believed. Many plumbing problems can be solved easily with things on hand, or with a few inexpensive parts. Next time you have a problem with your plumbing, try using the tips in this article to solve it yourself!…